Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
199
wlan hw-retries
Description
With this command, you specify the number of retries. The hardware repetition is performed
by the WLAN chip itself when it tries to repeat an unacknowledged packet immediately.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan hw-retries <1-60>
The parameter has the following meaning:
Number of retries 1 ... 60
The number of retries is specified.
You display the setting with the show wlan advanced <wlan 0/X> command.
wlan max tx-power
Description
With this command, you specify the transmit power of the SCALANCE W700 device. It may
be necessary to reduce the transmit power when using antennas to avoid exceeding the
maximum legal transmit power. Reducing the transmit power effectively reduces cell size.
Note
The maximum possible transmit power varies depending on the channel and data rate. For
more detailed information on transmit power,
refer to the documentation "Characteristics
To Next Page
Loading...
Need help?
General
