Siemens SIMATIC NET

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
397
10.2.2.7
no wlan security ap-radius-authenticator primary
Description
With this command, you disable the primary server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
no wlan security ap-radius-authenticator primary <index (1-2)>
The parameter has the following meaning:
Parameters
Description
Range of values / note
index
Index of the RADIUS server
1...2
Result
The primary server is disabled.
Further notes
You enable the setting with the wlan security ap-radius-authenticator primary command.
You display the setting with the
show wlan security ap-radius-authenticator command.
See also
wlan security ap-radius-authenticator primary (Page 396)
show wlan security ap-radius-authenticator (Access Point) (Page 389)