System time
5.1 System time setting
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
114 Configuration Manual, 10/2015, C79000-G8976-C351-05
show dst info
Description
This command shows all the entries for daylight saving time stored on the device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show dst info
The entries for daylight saving time are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General
