Description
2.6 General CLI commands
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
33
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
This command shows the last 14 commands you entered.
The commands are listed in the order in which they were called up. The
show history
command is listed as the last command to be entered.
The list depends on the mode. In the Global configuration mode, the last 14 commands
entered in this mode are displayed. These commands are not included in the list of the
Interface configuration mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show history
The list of used commands is displayed.
To Next Page
Loading...
Need help?
General
