Siemens SIMATIC NET

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
242 Configuration Manual, 10/2015, C79000-G8976-C351-05
Syntax
Call up the command with the following parameters:
show spanning-tree [{summary|blockedports|pathcost method}]
The parameters have the following meaning:
Parameter
Description
summary
Shows a summary
blockedports
Shows the blocked ports
pathcost method
Shows whether 16-bit (short) or 32 bit (long) values are used in the calcula-
tion
Result
The settings for the spanning tree function are displayed.
Further notes
You can show further settings for special aspects of the Spanning Tree Protocol with the
following commands:
●
show spanning-tree active
●
show spanning-tree bridge
●
show spanning-tree detail
●
show spanning-tree interface
●
show spanning-tree root
●
show spanning-tree mst
6.3.1.2
show spanning-tree active
Description
This command shows the settings for the active ports of the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#