Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
399
wlan security ap-radius-authenticator reauth-mode
Description
With this command, you specify who decides the time before the clients are forced to
reauthenticate.
Note
This command is available only in access poin
t mode.
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Call up the command with the following parameters:
wlan security ap-radius-authenticator reauth-mode {show-modes | <mode>}
The parameters have the following meaning:
Lists the available values.
• disabled
Function is disabled
• server
Time management on the server
• local
Local time management. You specify
the period of validity with the
wlan se-
curity ap-radius-authenticator
command.
Method of time management
The function is configured.
You display the setting with the show wlan security ap-radius-authenticator command.
wlan security ap-radius-authenticator reauth-interval (Page 398)
show wlan security ap-radius-authenticator (Access Point) (Page 389)
To Next Page
Loading...
Need help?
General
