Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
77
With this command, you copy a file from the file system of the device to a TFTP server. The
TFTP protocol is used for the transfer. You can also display a list of available files.
● The name of the file is specified
● You are in the LOADSAVE configuration mode.
The command prompt is:
cli(config-loadsave)#
Call up the command with the following parameters:
tftp save {showfiles|filetype<filetype>}
The parameters have the following meaning:
Shows the available files
Keyword for a file type to be loaded
The file types are displayed or the file is copied.
You configure the name of the file with the tftp filename command.
With the "
show loadsave files" command, you can display the file types.
With this command, you configure the access to a TFTP server.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
To Next Page
Loading...
Need help?
General
