Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
401
wlan security context (Client)
Description
With this command, you create a new security context and change to the security context
configuration mode.
Note
This command is only available in the client mode.
You are in the WLAN configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Call up the command with the following parameters:
wlan security context <ID (1-8)>
The parameter has the following meaning:
ID of the security context
The security context is created,
You are in the security context configuration mode.
The command prompt is as follows:
cli (config-wlan-context-$)#
You exit the security context configuration mode with the command end or exit.
You delete a security context with the
no wlan security context command.
You display the setting with the
show wlan security command.
To Next Page
Loading...
Need help?
General
