Functions specific to SCALANCE
4.1 WBM
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
92 Configuration Manual, 10/2015, C79000-G8976-C351-05
show web-session-timeout
Description
This command shows the timeout setting for the WBM.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show web-session-timeout
The timeout setting for the WBM is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
web-session-timeout
Description
With this command, you enable the automatic logoff and you configure the timeout setting for
the WBM.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
