Functions specific to SCALANCE
4.3 iPCF
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
100 Configuration Manual, 10/2015, C79000-G8976-C351-05
This section describes the commands relevant for working with the iPCF function (industrial
Point Coordination Function).
Note
The commands are only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
This command shows the settings of iPCF.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
