Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
317
You delete the DHCP option with the no option command.
Note
The command is only available when the following requirements are met:
SCALANCE W722-1 RJ45 (article no.: 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-
0AB0 (US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
The IPv4 address band is not enabled.
With this command you configure the DHCP option 67 and the name of the boot file as
DHCP parameter. The DHCP option 67 is created automatically when the IPv4 address
band is created.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
option <option-code> value-string <dhcp-param>
The parameters have the following meaning:
Name of the boot file -
The DHCP option 67 is configured. In total a maximum of 20 DHCP options are possible.
You display the setting with the show ip dhcp-server pools command.
You delete the DHCP option with the
no option command.
You configure the DHCP options 3, 6 and 66 with the
option command.
You disable the IPv4 address band with the
no pool-enable command.
You configure all other DHCP options with the
option value-hex command.
To Next Page
Loading...
Need help?
General
