Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
339
no snmp filterprofile
Description
With this command, you delete a filter.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no snmp filterprofile<profile-name><OIDTree>
The parameters have the following meaning:
Name of the filter profile
Path information of the MIB tree
The filter is deleted.
You create a filter with the snmp filterprofile command.
You display the created filter with the
show snmp filter table command.
With this command, you configure the details of an SNMP group.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
