Siemens SIMATIC NET Configuration Manual

Description
2.6 General CLI commands
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
28 Configuration Manual, 10/2015, C79000-G8976-C351-05
2.6
General CLI commands
This section describes commands that you can call up in any mode.
2.6.1
clear screen
Description
With this command, you clear the screen.
The command prompt is displayed.
Syntax
Call the command without parameters:
clear screen
Result
The screen is cleared.
The command prompt is displayed.
2.6.2
do
Description
With this command, you can execute the commands from the Privileged EXEC mode in any
configuration mode.
Syntax
Call up the command with the following parameters:
do [command ]
To do this, you replace
[command ] with the command from the Privileged EXEC mode that
you want to execute.
Example
do show cli-console-timeout
Result
The command from the Privileged EXEC mode will be executed.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols