Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
304 Configuration Manual, 10/2015, C79000-G8976-C351-05
show ip dhcp-server pools
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
The command shows the DHCP server configuration of a specific IPv4 address band or all
IPv4 address bands and the corresponding DHCP options.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip dhcp-server pools [pool-id (1-5)]
The parameter has the following meaning:
ID of the addressed IPv4 address
band
1 ... 5
Only ID = 1 is supported.
The configuration of the DHCP server and the DHCP options is displayed.
To Next Page
Loading...
Need help?
General
