Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
323
The assignment is specified.
You display the setting with the show ip dhcp dhcp-server bindings command.
You disable the IPv4 address band with the
no pool-enable command.
You delete the assignment with the
no static-lease command.
Note
The command is only available when the followi
ng requirements are met:
SCALANCE W722-1 RJ45 (article no.: 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-
0AB0 (US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
The IPv4 address band is not enabled.
With this command, you delete the assignment of an IPv4 address to a MAC address.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
no static-lease { mac <mac-address> | client-id <string> }
The parameter has the following meaning:
Keyword for a MAC
-
Unicast MAC address Specify the MAC address.
To Next Page
Loading...
Need help?
General
