Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
219
show mac-address-table count
Description
With this command, you show the number of MAC addresses for all or a selected VLAN.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show mac-address-table count[vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
The number of MAC addresses for the selected VLAN is displayed.
show mac-address-table dynamic unicast
Description
This command shows the MAC addresses of the dynamic unicast configuration.
● In "base bridge-mode", the mode for the device is set to "transparent".
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
