Functions specific to SCALANCE
4.5 Spectrum analyzer
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
109
WLAN Interface configuration mode
This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
interface wlan 0/X command to change to this
mode.
● If you exit the WLAN Interface Configuration mode with the
exit command, you return to
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
end command, you return to
the Privileged EXEC mode.
wlan spectrumanalyzer centerfrequency (Access Point)
Description
With this command you select the center frequency for measuring with the spectrum
analyzer.
Note
This command is available only in acce
ss point mode.
● The WLAN interface is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan spectrumanalyzer centerfrequency { show-frequencies | frequency}
To Next Page
Loading...
Need help?
General
