Siemens SIMATIC NET

Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
70 Configuration Manual, 10/2015, C79000-G8976-C351-05
3.2.1.1
show loadsave files
Description
This command shows the current Load&Save file information.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show loadsave files
Result
The current Load&Save file information is displayed.
3.2.1.2
show loadsave tftp
Description
This command shows the current configuration of the TFTP server for Load&Save.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show loadsave tftp
Result
The current configuration of the TFTP server for Load&Save is displayed.