Siemens SIMATIC NET

Configuration
3.5 SINEMA
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
88 Configuration Manual, 10/2015, C79000-G8976-C351-05
3.5.2.1
sinema
Description
With this command, you enable the SINEMA configuration interface.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
sinema
Result
The SINEMA configuration interface is enabled.
Further notes
You disable the SINEMA configuration interface with the no sinema command.
You display the setting whether the SINEMA configuration interface is enabled or disabled
with the command
show sinema.