Siemens SIMATIC NET

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
245
Syntax
Call up the command with the following parameters:
show spanning-tree interface <interface-type><interface-id>
[{cost|priority|portfast|rootcost|restricted-role|
restricted-tcn|state|stats|detail}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
cost
Shows the port costs used to calculate
the lowest-cost path.
-
priority
Shows the priority of the port. -
portfast
Shows whether spanning-tree port-
fast is enabled.
-
rootcost
Shows the costs of the path to the root
bridge.
-
restricted-role
Shows whether spanning-tree re-
stricted-role is enabled.
-
restricted-tcn
Shows whether spanning-tree re-
stricted-tcn is enabled.
-
state
Shows the status of the interface.
-
stats
Shows the counters of the various
BPDU transmissions.
-
detail
Shows detailed information about the
spanning tree settings of the interface.
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The settings of the ports for the spanning tree function are displayed.
6.3.1.6
show spanning-tree l2t-edge
Description
This command displays the status of the layer 2 tunnel ports.
Note
This command is available only in a
ccess point mode.