System time
5.3 SNTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
123
Call up the command with the following parameters:
ntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Time zones to the west of the NTP server time zone
Time zones to the east of the NTP server time zone
Number of hours difference
Number of minutes difference
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
The time difference between the device and the NTP server is configured.
This section describes commands relevant for configuration of the SNTP client.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
To Next Page
Loading...
Need help?
General
