Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
260 Configuration Manual, 10/2015, C79000-G8976-C351-05
spanning-tree priority
Description
With this command, you configure the priority of the device. Which device becomes the root
bridge is decided based on the priority. The bridge with the highest priority becomes the root
bridge. The lower the value, the higher the priority.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
spanning-tree[mst <instance-id(1-64)>] priority <value(0-61440)>
The parameters have the following meaning:
Keyword for a Multiple Spanning Tree
-
Number of the instance 1 ... 64
Value for the priority 0 ... 61440
You can only change the value for the priority in the steps of 4096.
The priority of the device is configured.
You can reset the setting to the default with the no spanning-tree priority command.
You display this setting and other information with the commands that start with
show
spanning-tree ...
.
To Next Page
Loading...
Need help?
General
