Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
271
spanning-tree bpdu-transmit
Description
With this command, you enable or disable the BPDU transmit status at the port.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree bpdu-transmit{enabled|disabled}
The parameters have the following meaning:
BPDU packets are transmitted at the
Default: enabled
BPDU packets are not transmitted at
the port
-
The BPDU transmit status has switched over.
You can display the status of this function and other information with the show spanning-tree
interface
command with the detail option.
spanning-tree mst
Description
With this command, you configure the various properties of the Multiple Spanning Tree
function:
● With the
cost option, you configure the port costs used to calculate the lowest-cost path.
● With the
port-priority option, you configure the priority of the interface for negotiating a
Multiple Spanning Tree configuration.
● With the
disable option, you disable the interface for the Multiple Spanning Tree function.
To Next Page
Loading...
Need help?
General
