Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
59
The parameter has the following meaning:
The name is created in the system.
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
alias <interface-name>
The parameter has the following meaning:
Name of the interface max. 63 characters
To Next Page
Loading...
Need help?
General
