Siemens SIMATIC NET

Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
294 Configuration Manual, 10/2015, C79000-G8976-C351-05
7.1.2.13
ip domain used server
Description
This command specifies which DNS server the device uses.
Note
Only resource
records of type A (IPv4 address of a host) are supported.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip domain used server {learned-only | manually-only | all}
The parameters have the following meaning:
Parameter
Description
Range of values / note
learned-only
The device uses only the DNS servers
assigned by DHCP.
-
manually-only
The device uses only the manually con-
figured DNS servers. A maximum of
three DNS servers can be configured.
-
all
The device uses all available DNS serv-
ers.
-
Result
The device uses the DNS servers specified in the configuration.