Network protocols
7.2 DHCP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
300 Configuration Manual, 10/2015, C79000-G8976-C351-05
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip dhcp client
The configuration settings of the DHCP client are displayed.
This command reassigns an IP address to the selected interface via DHCP.
● The IP address of the selected interface was assigned via DHCP.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call up the command with the following parameters:
renew dhcp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
To Next Page
Loading...
