Siemens SIMATIC NET Configuration Manual

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
330 Configuration Manual, 10/2015, C79000-G8976-C351-05
7.4.1.11
show snmp user
Description
This command shows the settings for the SNMP user.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp user
Result
The settings for the SNMP user are displayed.
7.4.1.12
show snmp viewtree
Description
This command shows the settings for the SNMP tree views.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp viewtree
Result
The settings for the SNMP tree views are displayed.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols