Siemens SIMATIC NET

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
239
6.2.4.4
no ports
Description
With this command, you reset the ports for a VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ports
(
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>] [all]
)
[
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>] [all]
)
]
[
(
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>] [all]
)
]
[name<vlan-name>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Enter a valid interface.
/a-b,0/c,...
Port no. of the interface
untagged
Keyword for interfaces or ports that transfer
data packets without VLAN marking
-
all
Specifies that all interfaces or ports are set
to "untagged"
-
forbidden
Keyword for forbidden interfaces or ports
-
name
Keyword for the name assignment
-
vlan-name
Name of the VLAN
max. 32 characters