SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
113
This part contains the sections describing how the system time is obtained and the settings.
This section describes commands relevant for the configuration of the system time.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
This command shows the settings of the system clock.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show time
The settings for the system clock are displayed.
To Next Page
Loading...
Need help?
General
