Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
193
Syntax
Call the command without parameter assignment:
wlan force roaming eth-down
Result
The function is enabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You disable the function with the
no wlan force roaming eth-down command.
6.1.5.42
no wlan force roaming eth-down (access point)
Description
With this command, you disable roaming if the connection aborts on the Ethernet interface.
This setting is activated as default.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan force roaming eth-down
Result
The function is disabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You enable the function with the
wlan force roaming eth-down command.