Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
78 Configuration Manual, 10/2015, C79000-G8976-C351-05
cli(config-loadsave)#
Call up the command with the following parameters:
tftp server {ipv4 <ucast-addr> | fqdn-name <FQDN>} [port<tcp port(1-65535)>]
The parameters have the following meaning:
Keyword for an IPv4 address
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum 100 characters
Keyword for the port of the server via
which the TFTP connection runs
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The settings for the access to the selected TFTP server are configured.
With this command, you activate and configure the password for encrypted certificates.
User, server or HTTPS certificates can exist as PKCS#12 certificates (.p12 and .pfx) and
PEM certificates (.pem).
Note
User and server certificate in one file
If the user and the server certificate are loc
ated in the same file, load this file on the device
as the user certificate and as the server certificate.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
To Next Page
Loading...
Need help?
General
