Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
405
Commands in the security context configuration mode
This section describes commands that you can call up in the security context configuration
mode.
In the WLAN configuration mode, enter the
wlan security context <ID (1-8)> command to
change to this mode.
● If you exit the security context configuration mode with the
exit command, you return to
the WLAN configuration mode.
● If you exit the security context configuration mode with the
end command, you return to
the Privileged EXEC mode.
wlan security authentication (client)
Description
With this command, you specify the type of authentication.
Note
This command is only available in the client mode.
Note
iPCF or iPCF-MC mode enabled
If iPCF or iPCF
-MC mode is enabled, only "Open System" with the encryption method AES
is supported in the security settings.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
To Next Page
Loading...
Need help?
General
