Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
157
Further notes
You display the list of valid channels with the show wlan allowed channels <wlan 0/X>
command.
The "Allowed channels only" function is activated by the "
wlan allowed channels only"
command.
See also
wlan allowed channels only (Page 157)
6.1.5.2
wlan allowed channels only
Description
With this command, you enable the "Use allowed channels only" function. Only the channels
you specified with the
wlan allowed channels list command are used.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan allowed channels only
Result
The function is enabled.
Further notes
You display the setting with the show wlan allowed channels <wlan 0/X>command.
You disable the function with the
no wlan allowed channels only command.
See also
wlan allowed channels (Page 155)
no wlan allowed channels only (Page 158)