Siemens SIMATIC NET Configuration Manual

Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
451
11.1.6.9
severity
Description
With this command, you configure the threshold values for the sending of system event
notifications.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Syntax
Call up the command with the following parameters:
severity { mail | log | syslog | authlog } { info | warning | critical }
The parameters have the following meaning:
Parameter
Description
Range of values / note
mail
System event messages are sent by e-
mail.
-
log
System event messages are entered in
the log table.
-
syslog
System event messages are entered in
the syslog file.
-
authlog
System event messages are entered in
the log table for authentications.
-
info
System events are processed as of the
severity level "Information".
-
warning
System events are processed as of the
severity level "Warning".
-
critical
System events are processed as of the
severity level "Critical".
-
Result
The settings for sending system event messages are configured.
The "severity" function is enabled.
Further notes
You disable the setting with the no severity command.
You display the status of this function and other information
show events severity

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols