Diagnostics
11.2 Syslog client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
453
With the commands in this section, the following settings are configured:
● Transfer of the messages to the Syslog server
● Local buffering and storage of messages
● Receipt and forwarding of messages from other devices (relay mode)
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show events syslogserver
Description
This command shows the entries of the configured Syslog server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show events syslogserver
The entries of the configured Syslog server are displayed.
To Next Page
Loading...
Need help?
General
