Security and authentication
10.1 User rights management
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
387
With this command, you change the password of the factory set default users "user" and
"
admin".
● The user is logged in with the "admin" role.
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
username {user|admin} password <passwd>
The parameters have the following meaning:
User name of the default user with
read access to the configuration
Enter "user".
User name of the default user with
read and write access to the con-
Enter "admin".
Value for the password Enter the password.
The password must be at least 6 charac-
The password is changed.
Note
Changing the password in Trial mode
Even if you change the password in Trial mode, this change
is saved immediately.
You create a user with the user-account command.
You delete a user with the
no user-account command.
You show the created users with the
show user-accounts command.
To Next Page
Loading...
Need help?
General
