Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
237
Call the command without parameters:
no name
The name of the VLAN is deleted.
You assign the VLAN a name with the command name.
With this command, you generate a static VLAN entry that specifies the use of the ports.
Here, you configure the following types of ports:
● Member ports (tagged ports)
These ports are permanently added to the list of outgoing connections
● Untagged ports
These ports transfer data packets without a VLAN marking
● Forbidden ports
These ports are not used for communication in a VLAN
The tagged and untagged ports specified with this command are used for outgoing data
traffic.
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
To Next Page
Loading...
Need help?
General
