Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
222 Configuration Manual, 10/2015, C79000-G8976-C351-05
show vlan learning params
Description
This command shows the parameters for the automatic learning of addresses for selected or
all VLANs (active and inactive VLANs).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show vlan learning params[vlan<vlan-range>]
The parameters have the following meaning:
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
1 ... 4094
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
The settings for the automatic learning of addresses are displayed.
show vlan port config
Description
This command shows the VLAN-specific information for ports.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
