Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
254 Configuration Manual, 10/2015, C79000-G8976-C351-05
The automatic discovery of a bridge on the interface is disabled.
You enable the automatic detection with the spanning-tree l2t-auto-edge command.
You can display the status of this function with the
show spanning-tree l2t-edgecommand.
spanning-tree l2t-edge
Description
With this command, you specify that an end device can be located at a layer 2 tunnel port.
Otherwise a reconfiguration of the network will be triggered whenever a link to this port is
modified. The L2T clients should be interconnected.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
spanning-tree l2t-edge
The setting is enabled.
You disable the setting with the no spanning-tree l2t-edge command.
You can display the status of this function with the
show spanning-tree l2t-edgecommand.
To Next Page
Loading...
Need help?
General
