Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
184 Configuration Manual, 10/2015, C79000-G8976-C351-05
You display the setting with the show wlan data rates command.
You enable the function with the
wlan data rates-11n selected only command.
You configure the transmission standard with the
wlan mode command.
wlan data rate-11abg defaults (access point)
Description
You can reset the selection to the default setting with this command.
Note
This command is available only in access point mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11a/b/g/n is set.
● The "Use selected data rates only" function is enabled.
Call the command without parameter assignment:
wlan data rate-11abg defaults
The selection is reset to the default setting.
You display the setting with the show wlan data rates command.
You disable the function with the
no wlan data rates-11abg selected only command.
You configure the data transmission speeds with the
wlan data rate-11abg command.
You configure the transmission standard with the
wlan mode command.
To Next Page
Loading...
Need help?
General
