Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
203
With this command, you enable the outdoor mode. In outdoor mode, the selection of country-
dependent channels and the transmit power for operation are restricted for outdoor use.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
wlan outdoor
The outdoor mode is enabled.
You display the setting with the show wlan basic <wlan 0/X> command.
You disable the function with the
no wlan outdoor command (default setting).
no wlan outdoor (Page 203)
no wlan outdoor
Description
With this command, you disable the outdoor mode or enable the indoor mode. This setting is
activated as default.
In indoor mode, all the country-dependent permitted channels and transmit power settings
are available for operation in a building.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
no wlan outdoor
To Next Page
Loading...
Need help?
General
