Siemens SIMATIC NET - Page 202

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
202 Configuration Manual, 10/2015, C79000-G8976-C351-05
Syntax
Call up the command with the following parameters:
wlan mode { show-modes | [2.4 | 5] <mode>}
The parameters have the following meaning:
Parameters
Description
Range of values / note
show-
modes
Lists the transmission standards. --
2.4
Optional. You can use the parameter in
conjunction with "auto" and "n". This
only takes into account the transmis-
sion standard for 2.4 GHz.
Use the parameter if the client operates
in dual-frequency mode.
--
5
Optional. You can use the parameter in
conjunction with "auto" and "n". This
only takes into account the transmis-
sion standard for 5 GHz.
Use the parameter if the client operates
in dual-frequency mode.
--
mode
Value corresponding to a specific
transmission standard.
•
auto
The transmission standard is detected
automatically.
•
a
IEEE 802.11a (5 GHz)
• g
IEEE 802.11g (2.4 GHz)
Is downwards compatible with IEEE
802.11b
•
n
IEEE 802.11n (2.4 GHz + 5 GHz)
Is downwards compatible with IEEE
802.11a and IEEE 802.11g
•
n-only
IEEE 802.11n (2.4 GHz + 5 GHz)
Is not downwards compatible with IEEE
802.11a and IEEE 802.11g
Depending on the current configuration, some settings are not possible. In this case, a
message to this effect is displayed.
Result
The transmission standard is specified.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.