Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
376 Configuration Manual, 10/2015, C79000-G8976-C351-05
You show the NAT configuration and the translation list with the show nat command.
You configure entries with the
nat command.
show nat (Client) (Page 371)
nat local ip address (Client)
Note
This command is only available in the client mode.
With this command, you configure the IP address of the Ethernet interface. This IP address
is the gateway address of the local device.
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Call up the command with the following parameters:
nat local ip address <ip-address> {<subnet-mask>|/<prefix-length(0-32)>
The parameters have the following meaning:
Address of the Ethernet interface
Subnet mask of the local Ethernet
enter a valid subnet mask
length
Decimal representation of the mask as
1 ... 32
The local IP address of the Ethernet interface is configured.
To Next Page
Loading...
Need help?
General
