Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
54 Configuration Manual, 10/2015, C79000-G8976-C351-05
The placeholder $$$ is replaced by the following name of the interface:
The placeholders $ or $-$ denote the numbering of the interface.
For the value ranges for the VLAN logical interface, refer to the upper table. You can only
call up interfaces that you created with the
vlan command.
The ranges of values from the physical interfaces depend on the hardware configuration.
You exit the Interface Configuration mode with the end or exit command.
You delete a logical interface with the
no interface command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
With this command, you delete a logical interface.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>}
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
The logical interface is deleted.
To Next Page
Loading...
Need help?
General
