Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
188 Configuration Manual, 10/2015, C79000-G8976-C351-05
Requirement
● DFS is enabled.
● The access point does not select the channel automatically.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan dfs prefer-configured-channel
Result
The function is enabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You disable the function with the
no wlan dfs prefer-configured-channel command (default
setting).
6.1.5.36
no wlan dfs prefer-configured-channel
Description
With this command you disable the access point changing back to the configured channel
automatically after the channel is released again following a blockage.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dfs prefer-configured-channel
Result
The function is disabled.