Siemens SIMATIC NET

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
335
The parameters have the following meaning:
Parameter
Description
Range of values / note
GroupName
Name of the group to which access is
deleted
max. 32 characters
Version Selects the version of the protocol
used
•
v1
•
v2c
•
v3
Authentication Selects the authentication method:
•
auth
•
noauth
•
priv
Result
The access to an SNMP group is deleted.
Further notes
You configure the setting with the snmp access command.
You display the configured SNMP groups with the
show snmp group command.
You display the access configurations for SNMP groups with the
show snmp group access
command.
You display the configured SNMP tree views with the
show snmp viewtree command.
7.4.2.6
snmp community index
Description
With this command, you configure the details of an SNMP community.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp community index <CommunityIndex> name <CommunityName>
security <SecurityName> [context <Name>][{volatile|nonvolatile}]