Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
337
Call up the command with the following parameters:
no snmp community index <CommunityIndex>
The parameter has the following meaning:
The details of an SNMP community are deleted.
You configure the details of an SNMP community with the snmp community index command.
You show the details of an SNMP community with the
show snmp community command.
You show the status information of the SNMP communication with the
show snmp command.
snmp filterprofile
Description
With this command, you configure a filter that describes the access rights to the MIB tree.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
