Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
64 Configuration Manual, 10/2015, C79000-G8976-C351-05
The parameters have the following meaning:
the sending of LLDP packets is enabled
the receipt of LLDP packets is disabled
Note
Disabling both options
When you call this command, you can only select one option.
If you want to disable both options, call up the command again.
The setting is configured.
You enable the sending or receipt of LLDP packets with the lldp command.
You display the status of LLDP with the
show lldp status command.
With this command, you configure the size of the Maximum Transmission Unit (MTU) for an
interface.
● The Interface must be shut down.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
mtu <frame-size(64-1514)>
To Next Page
Loading...
