Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
250 Configuration Manual, 10/2015, C79000-G8976-C351-05
With this command, you enable the spanning tree function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
spanning-tree
The spanning tree function is enabled.
As default the function is "enabled".
You disable the spanning tree function with the
no spanning tree command.
You can display the status of this function and other information with the
show spanning tree
detail
command.
You can display information about active ports with the
show spanning tree active
command.
no spanning-tree
Description
With this command, you disable the spanning tree function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no spanning-tree
To Next Page
Loading...
Need help?
General
