Description
2.5 Interface identifiers and addresses
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
25
Interface identifiers and addresses
2.5.1
Naming interfaces
Addressing interfaces
The device has several types of interface that are addressed in different ways:
Addressing physical interfaces
This notation also applies to other commands that address an Interface.
● Enter the command "
interface".
● Specify the interface type
<interface-type>.
● After a space, enter the interface identifier,
<interface-id>.
The interface identifier is made up of the module number and the port number separated
by a slash. The interfaces permanently installed in the device are identified with module
0.
Examples:
Fast Ethernet:
interface fa 0/1
WLAN1:
interface wlan 0/1
Addressing logical interfaces
This notation also applies to other commands that address a logical interface.
● VAP / WDS
– Enter the command "
interface".
– Specify the interface type
<interface-type>.
– After a space, enter the interface identifier,
<interface-id>.
The interface identifier is made up of the module number and the port number
separated by a slash. The interfaces permanently installed in the device are identified
with module 0.
Example:
VAP 1.1:
interface vap1 0/1
● VLAN
– Enter the command "
interface".
– Enter the keyword for the VLAN interface.
– After a space, enter the number of the VLAN interface you assigned when you created
it.
Example:
VLAN 2:
interface vlan 2
To Next Page
Loading...
Need help?
General
